Completing the installation

Ready to install the program

To start the installation, click Install. To change any of the previous selections, click Back. To quit the installation, click Cancel.

Note: If you have elected to install a Client (Student), the Setup will make the required amendments to your System.INI and/or registry, to load the Student as Windows initialises. NetSupport School CCE will not replace any of your existing drivers.

Installation complete

To complete the installation:

Choose whether to run the Student Configurator. This enables you to set basic Student information and security.

Click Finish to exit the Setup program.

Note: Access to the NetSupport School CCE Tutor component can be restricted to designated users, see the Restricting Access to the NetSupport School CCE Tutor in Windows MultiPoint Server 2012 document on our website, www.netsupportsoftware.com for further information.